01 / 01

MANUFACTURING

MANUFACTURING OF RUBBERWOOD FURNITURE AND COMPONENTS

MANUFACTURING OF RUBBERWOOD

OVER 25 YEARS TRACK RECORDSImage

SYF is among the leading furniture and rubberwood components manufacturer in Malaysia, specializing in the production of dining furniture, bedroom furniture, kiln dry sawn timber and lamination board, using rubberwood as the main source of raw material. As a plantation sourced specie that is renewable and abundant in Malaysia, the use of rubberwood fulfils our pledge to support an eco-friendly environment.

Exporting to over 80 countries worldwide, we strive to build strategic relationships with each and every one of our customers. Our commitment is to deliver quality, reliability and consistency in both our products as well as service.

Strategically located within the Klang Valley, SYF’s manufacturing facilities cover more than 40 acres of industrial land and are fully integrated. With processes commencing from sawmilling, treatment of sawn timber, kiln drying, materials processing and manufacturing of component parts to finishing and assembly of completed furniture, we are a one-stop manufacturer with end-to-end capability.

MANUFACTURING PROCESS

Our manufacturing process allows us to consistently produce high quality furniture and wood products that have been exceeding customer expectations for decades.

Step One

Pressure Treatment

This is where the sawn wood is treated to ensure it has the longevity needed. The pressure chamber is vacuum sealed and preservatives are applied to treat the wood so that it will resist fungal and termite attack.

Step Two & Three

Stacking & Sorting followed by Kiln Drying

After pressure treatment, the timber will be sorted, properly stacked for drying in a kiln before the next step.

Step Four, Five & Six

Cross-cutting, Moulding & Finger Joints

After the timber is dried, it will be ready for cross-cutting to get the useful wood pieces out of the timber. The cut pieces are then moulded and then joined into longer strips by the process of finger jointing.

Step Seven, Eight & Nine

Lamination, Furniture Parts, Wood Working & Spraying

Subsequently the strips go through a lamination process to produce laminated boards. These are then further machined to various furniture parts that are cut in accordance to the design of a particular set of furniture. Wood working is a further process to bring the various furniture parts to the required shapes and smoothness. Finally, the various furniture pieces are sprayed with relevant paint and dried.

Step Ten, Eleven & Twelve

Assembly, Packing and Storing

Assembly of the various pieces of furniture is done before these are packed in cardboard boxes. The complete packed assembly is then stacked and stored awaiting shipment to customers.

Dining Set

Bedroom Set

Get in touch

contacts
SYF RESOURCES BERHAD ( 364372-H ), Lot 971, Batu 23 1/2, Jalan Sungai Lalang,
43500Semenyih, Selangor Darul Ehsan, Malaysia
+6 (03) – 8723 4535
+6 (03) – 8723 8500

Thank you!. Your message is successfully sent...
We're sorry, but something went wrong
©SYF Resources Bhd.. All Rights Reserved.